Garbage Disposal Installation
Jammed, humming, leaking or simply done. Replaced properly with the drain arrangement corrected rather than reused as-is.
Garbage Disposal Installation in the South Bay
How we approach it
A disposal that hums without turning is jammed, not dead, and that is usually a five minute job. A disposal that leaks from the body is finished — the housing has corroded through and there is nothing to seal.
When we replace one we redo the drain arm and trap arrangement at the same time. Reusing a marginal setup is how you end up back under the sink in six months.
What the job covers
- Jam clearing and reset
- Motor and switch diagnosis
- Full unit replacement, any common brand
- Drain arm, trap and dishwasher tie-in redone
- Sink flange re-seal
- Old unit removed and taken away
Signs you are looking at this job
- Humming with no rotation
- Water pooling in the cabinet below
- A grinding noise that will not clear
- Persistent smell that survives cleaning
- Slow draining on the disposal side only
Not sure which one it is?
Describe it however it comes out — the noise, the smell, where the water is. We ask the few questions that narrow it down and tell you whether it needs someone today or whether it can wait until the week.
No trip charge for a quote inside the service area, and a flat number before any work starts.
You call
Tell us what it is doing. We ask what narrows it down and give you a window we can actually keep.
We diagnose
On site, with the right instruments. You see what we see before anything gets opened up.
Flat quote
One number, written down. If something turns up behind the wall we stop and re-quote rather than run the meter.
Clean finish
Tested, walked through with you, and the work area left the way you handed it over.
Let’s get it flowing again.
Tell us what it is doing and we will tell you what it takes. No trip charge for a quote in the service area.