Gas Line Repair
Leak testing, repair and new runs for ranges, dryers, heaters, fire pits and generators — pressure tested and inspected.
Gas Line Repair in the South Bay
How we approach it
Gas work is not the place for approximation. Every run gets sized for the load it has to carry and the distance it has to carry it, and every joint gets pressure tested before it goes into service.
If you smell gas right now, leave the building and call the gas utility from outside first. Then call us.
What the job covers
- Leak location and repair on existing runs
- New appliance runs and stub-outs
- Line sizing for total connected load
- Sediment traps and shut-off valves at appliances
- Pressure testing and permit inspection
- Corrugated stainless and black iron work
Signs you are looking at this job
- A gas smell near an appliance or meter
- A pilot that will not stay lit
- Adding a range, dryer, heater or outdoor appliance
- A new tankless unit that needs more gas than the line carries
- Visible corrosion on exposed gas piping
Not sure which one it is?
Describe it however it comes out — the noise, the smell, where the water is. We ask the few questions that narrow it down and tell you whether it needs someone today or whether it can wait until the week.
No trip charge for a quote inside the service area, and a flat number before any work starts.
You call
Tell us what it is doing. We ask what narrows it down and give you a window we can actually keep.
We diagnose
On site, with the right instruments. You see what we see before anything gets opened up.
Flat quote
One number, written down. If something turns up behind the wall we stop and re-quote rather than run the meter.
Clean finish
Tested, walked through with you, and the work area left the way you handed it over.
Let’s get it flowing again.
Tell us what it is doing and we will tell you what it takes. No trip charge for a quote in the service area.